Dodge Intrepid - Page 767

INSTALLATION
(1) Place latch in position in door.
(2) Install screws attaching door latch to door end
frame.
(3) Connect outside door handle link to door latch.
(4) Connect lock button link to door latch.
(5) Install rear glass channel.
(6) Verify door latch operation.
(7) Install door trim panel.(Refer to 23 - BODY/
DOORS - REAR/TRIM PANEL - INSTALLATION)
LATCH STRIKER
REMOVAL
(1) Open rear door.
(2) Mark location of door latch striker on C-pillar
to assist installation alignment.
(3) Remove bolts holding striker to C-pillar (Fig.
7).
(4) Remove door latch striker from vehicle.
INSTALLATION
(1) Place door latch striker in position on vehicle.
(2) Install bolts attaching striker to C-pillar.
(3) Align striker to marked location on C-pillar
and tighten bolts.
(4) Verify alignment and operation of door, adjust
as necessary.
Fig. 6 REAR DOOR LATCH
1 - TO LOCK BUTTON
2 - CLIPS
3 - WIRE CONNECT
4 - REAR DOOR LATCH
5 - TO DOOR HANDLE
Fig. 7 REAR DOOR LATCH STRIKER
1 - C-PILLAR
2 - DOOR LATCH STRIKER
23 - 30 DOORS - REAR LH
LATCH (Continued)