COWL GRILLE AND SCREEN
REMOVAL
(1) Release hood latch and open hood.
(2) Remove wiper arms. (Refer to 8 - ELECTRI-
CAL/WIPERS/WASHERS/WIPER ARMS -
REMOVAL)
(3) Remove screws attaching cowl screen at the
windshield and under hood (Fig. 2).
(4) Remove cowl screen from vehicle.
INSTALLATION
(1) Place cowl screen in position on vehicle.
(2) Install cowl screen screws, starting at fender
moving inboard.
(3) Install wiper arms. (Refer to 8 - ELECTRICAL/
WIPERS/WASHERS/WIPER ARMS - INSTALLA-
TION)
EXTERIOR NAME PLATES
REMOVAL
REMOVAL - DOUBLE SIDED TAPE
(1) Mark reference points before removing.
(2) Using a heat gun gently apply heat in a circu-
lar motion to loosen the adhesive bond.
(3) Using a nonmetallic prying device, such as a
plastic or wood trim stick gently pry up at corners
and remove.
(4) Clean off all traces of adhesive or double sided
tape from the panel with a general purpose adhesive
remover.
REMOVAL - ADHESIVES
(1) Mark reference points before removing.
(2) Using a heat gun gently apply heat in a circu-
lar motion to loosen the adhesive bond.
(3) With your fingernail lift up and peel away
badgeing/tape from panel, using a heat gun as you
go.
(4) Clean off all traces of adhesive from the pan-
el(s) with a general purpose adhesive remover.
INSTALLATION
INSTALLATION - DOUBLE SIDED TAPE
(1) Clean panel surface with isopropy alcohol.
(2) Align badgeing to reference points.
(3) Install and press securely to full adhesive con-
tact
(4) Clean away any reference points.
INSTALLATION - ADHESIVES
(1) Clean panel surface with isopropy alcohol.
(2) Remove paper carrier and align badgeing/tape
to reference points or adjacent panel.
(3) Install and press securely, using a plastic
spreader to eliminate all air bubbles.
(4) Remove top protective carrier.
(5) Clean away any reference points.
Fig. 2 COWL SCREEN
1 - PLENUM COWL SCREEN
2 - COWL SCREEN RIGHT
3 - COWL SCREEN LEFT
LH EXTERIOR 23 - 35
To Next Page
Loading...
