Dodge Intrepid - Page 795

INSTALLATION
(1) Place steering column cover into position (Fig.
14).
(2) Push on steering column cover till retaining
clips lock into position.
(3) Install two attaching screws to the side of the
steering column cover.
(4) Install end cover.
STEERING COLUMN COVER
REINFORCEMENT
REMOVAL
(1) Remove steering column cover (Refer to 23 -
BODY/INSTRUMENT PANEL/STEERING COLUMN
OPENING COVER - REMOVAL).
(2) Remove four bolts attaching steering column
cover reinforcement (Fig. 15).
(3) Remove diagnostic connector from the steering
column cover reinforcement.
(4) Remove steering column cover reinforcement
from vehicle.
INSTALLATION
(1) Place steering column cover reinforcement in
position.
(2) Connect diagnostic connector to the steering
column cover reinforcement.
(3) Install the four bolts attaching steering column
cover reinforcement (Fig. 15).
(4) Install steering column cover (Refer to 23 -
BODY/INSTRUMENT PANEL/STEERING COLUMN
OPENING COVER - INSTALLATION).
Fig. 15 STEERING COLUMN COVER
REINFORCEMENT
1 - INSTRUMENT PANEL
2 - STEERING COLUMN BRACKET
3 - CROSS CAR BEAM
4 - STEERING COLUMN COVER REINFORCEMENT
23 - 58 INSTRUMENT PANEL LH
STEERING COLUMN COVER (Continued)