Dodge Intrepid - Page 806

(5) Install fasteners attaching bottom of console
storage bin to rear mounting bracket.
(6) Connect the electrical connectors.
(7) Install side panels.
(8) Install center console shift bezel.
(9) Install shift knob.
FRONT DOOR WINDOW FRAME
MOLDING
REMOVAL
(1) Remove flag trim, speaker, door trim panel,
watershield as necessary, and mirror.
(2) Remove door glass run weatherstrip as neces-
sary to gain access to applique fasteners.
(3) Remove screws attaching molding to window
frame (Fig. 17).
(4) Remove molding from door.
INSTALLATION
(1) Place molding in position on door.
(2) Install screws attaching molding to window
frame.
(3) Install door glass run weatherstrip.
(4) Install the mirror, water shield, door trim
panel, speaker and flag trim.
Fig. 16 FLOOR CONSOLE
1 - CONSOLE BRACKET
2 - FASTENERS
3 - FLOOR CONSOLE
4 - FLOOR CONSOLE DUCT
5 - SHIFTER ASSEMBLY
Fig. 17 FRONT DOOR FRAME WINDOW
1 - REMOVE SCREWS
2 - LOOSEN HALFWAY
LH INTERIOR 23 - 69
FLOOR CONSOLE (Continued)