Dodge Intrepid - Page 851

REAR DOOR MOUNTED
WEATHERSTRIP
REMOVAL
(1) Using a fork type prying tool, disengage push
in fasteners attaching weatherstrip to lower door.
(2) Remove body mounted weatherstrip from pinch
weld around door opening (Fig. 7).
INSTALLATION
(1) Place door mount weatherstrip in position on
door with the paint dot in the upper corner of the
B-pillar.
(2) Install push pin fasteners to attach door
mounted weatherstrip to lower door.
(3) Verify door alignment and seal.
TRUNK OPENING
WEATHERSTRIP
REMOVAL
(1) Open decklid.
(2) Pull decklid weatherstrip from decklid opening
fence (Fig. 8).
(3) Remove weatherstrip from vehicle.
INSTALLATION
(1) Place weatherstrip in position on vehicle.
(2) Push decklid weatherstrip onto decklid opening
fence with molded joint at striker location.
(3) Verify decklid operation and sealing.
Fig. 7 REAR DOOR MOUNTED WEATHERSTRIP
1 - REAR DOOR OPENING
2 - REAR DOOR MOUNTED WEATHERSTRIP
3 - SEAL INSERT
4 - PAINT DOT
5 - PINCH FLANGE
Fig. 8 DECKLID WEATHERSTRIP - TYPICAL
1 - TRUNK LID WEATHERSTRIP
23 - 114 WEATHERSTRIP/SEALS LH