Domino G Series User Manual

Setting Name Description
X (mm) Set the horizontal position of the object in the template.
Y (mm) Set the vertical position of the object in the template.
Width (mm) Set the width of the object.
Height (mm) Set the height of the object.
Scale mode Set the scale mode of the object:
• Scale - The width and height of the object can be set•
independently.
• Auto size - The width and height of the object is•
controlled by the font size.
Angle Rotate the object.
Lock Lock the object to prevent it from being edited.
Visible Make the object printable or not printable.
Font family Set the font type.
Size (pt) Set the font size.
Style Choose:
• Bold•
•
Italic
•
• Underlined.•
Text align If the object has more than 1 line, set the alignment:
• Left•
•
Center
•
• Right.•
Remove blank line Remove blank lines from the object.
Remove leading space Remove leading spaces from the object.
8.
In the Counter tab, use the settings listed below to change counter object settings:8.
Name Description
Start value Set the counter object's start value.
End value Set the counter object's end value. When the counter reaches
this value, it will return to the start value.
Step value Set the counter object's increment/step value.
Repeat time Set the number of times each counter value will be repeated.
Prefix Set a prefix value for the counter object.
Sux Set a sux value for the counter object.
Padding character Set the number of padding characters (Range: 1 to 10)
Step Set the counting direction:
• Up•
•
Down.
•
OPERATION
110 EPT077343 EN - Issue 1 - 11 November 2022

Domino G Series Specifications

General

Brand	Domino
Model	G Series
Category	Laboratory Equipment
Language	English