4
Lay bracket on a flat surface and remove (4) screws from the display. See Fig 6.64.
Figure 6.64: Remove display
5
Turn the display over with the display face down s shown in Figure 6.65.
Figure 6.65: Connector board on back of display
6
Remove the (2) screws on the cable connect board and disconnect the cable/board from the
display as shown in Fig 6.66 .
Note!
Be sure not to lose the standoff washers.
WM048523 Rev 08 01/2019 129
6 Replacement Procedures
To Next Page
Loading...
