4
Disconnect speaker cable from R2 board as shown in Figure 14.5 below.
5
Disconnect annunicator/beeper cable from the R2 board and separate the cable from the wire
bundle as shown.
6
Disconnect the softkey cables from both softkeys.
Figure 14.5: Disconnect cables
Note: Many of the cables will remain connected to the R2 board.
7
Reference Figure 14.5 above, and disconnect the following cables from the secure door board:
•
24V power cable that goes to the sales display. Separate the cable from the bundle and
reconnect it to the secure door board .
•
CAN bus cable that goes to the R2 board.
•
Power cable that goes to the R2 board.
216 WM048523 Rev 08 01/2019
14 Models with Metal Electronic Head - IEC
To Next Page
Loading...
