6
Disconnect heater cable from the Heater control board and pull the cable out of the dispenser.
Fig 15.14.
Figure 15.14: Heater cable
7
Place absorbent pads down under the tank and in front of the dispenser, and place container
down in front of dispenser for draining the fluid from the tank.
8
For side A tank, disconnect the probe #3 from the temperature module. Fig 15.15.
Figure 15.15: Temp probe module
WM048523 Rev 08 01/2019 251
15 Helix 6000 DEF, Extra Narrow Model Dispensers - IEC
To Next Page
Loading...
