Draytek Vigor2762 series User Manual

Telnet Command: adsl txpct /adsl rxpct
Telnet Command: adsl txpct /adsl rxpct
This command allows the user to adjust the percentage of data transmission
(receiving/transmitting) for QoS application.
Syntax
Syntax
adsl txpct [auto:percent]
adsl rxpct [auto:percent]
Syntax Description
auto It means auto detection of ADSL transmission packet.
percent It means to specify the percentage of ADSL transmission
packet. Available range is 10-100.
Example
Example
> adsl txpct auto
% tx percentage : 80
> adsl txpct 75
% tx percentage : 75
Telnet Command: adsl status
Telnet Command: adsl status
This command is used to display current status of ADSL setting.
Syntax
Syntax
adsl status
Example
Example
> adsl status
--------------------- ATU-R Info (hw: annex A, f/w: annex A) ----------
Running Mode : State : TRAINING
DS Actual Rate : 0 bps US Actual Rate : 0
bps
DS Attainable Rate : 0 bps US Attainable Rate : 0
bps
DS Path Mode : Fast US Path Mode :
Fast
DS Interleave Depth : 0 US Interleave Depth : 0
NE Current Attenuation : 0 dB Cur SNR Margin : 0
dB
DS actual PSD : 0. 0 dB US actual PSD : 0. 0
dB
NE Rcvd Cells : 0 NE Xmitted Cells : 0
NE CRC Count : 0 FE CRC Count : 0
NE ES Count : 0 FE ES Count : 0
Xdsl Reset Times : 0 Xdsl Link Times : 0
ITU Version[0] : b5004946 ITU Version[1] : 544e0000
ADSL Firmware Version : 06-06-01-07-00-01
Power Management Mode : DSL_G997_PMS_NA
Test Mode : DISABLE
----------------------- ATU-C Info ---------------------------------
Far Current Attenuation : 0 dB Far SNR Margin : 0
dB
Vigor2762 Series User’s Guide
449

Draytek Vigor2762 series Specifications

General

Brand	Draytek
Model	Vigor2762 series
Category	Network Router
Language	English