107
2
PC Controller Setting
4
Programming a JOB for DC-646 Via Computer (PC Controller)
6.
Cut Trim Setting
Full Bleed Mode
: The lead margin and the trail
margin are chopped up and
dropped into the waste box.
No Bleed Mode
: Gutters shorter than 49 mm are
chopped up and dropped into the
waste box.
Process
All
: All of cut pieces are ejected to the
exit
tray
, except that gutters shorter than 28
mm and trail margin shorter than 49 mm
are chopped up and dropped into the
waste box.
5.
Slitter Guide
When using the module in the slot as a sliter guide,
select
Enable
. When not using it as a slitter guide,
select
Disable
.
Enable
is recommended for light weight documents.
RTM (rotary tool module (option))
and
Slitter
Module
can be used as slitter guides.
REFERENCE
7.
Crease Depth
Select
Max
,
Mid
, or
Min
.
Set this to
Max
for heavy weight documents and
Min
for light weight documents.
REFERENCE
Default is
Max
.
REFERENCE
If there is no lead margin or trail margin on a
document, select
No bleed mode
.
To Next Page
Loading...
