74
Adjusting Feeder
If the fi nished products are cut obliquely, adjust
skew using the
skew adjustment knob
.
Skew Compensation
Press the TEST key to perform a test run for one
sheet and check the fi nished products.
Clockwise: Turning the knob slightly shifts the
lead edge of the document toward the
operator's side.
Counterclockwise: Turning the knob slightly shifts
the lead edge of the document
toward the non-operators side.
If the skew remains, repeat steps 1 and 2 again.
To Next Page
Loading...
Need help?
General
