59
2
Function Setting
Basic Operations
3
< Function Setting 3 >
Apply shrinkage
In case printed documents are shrunk by heat generated on a digital printer, if the original
document size and document size after shrunk are entered, the DC-646 automatically
calculates the shrinkage ratio and adjusts cutting and creasing positions accordingly.
This function compensates for the shrinkage in the feed direction only.
REFERENCE
Apply shrinkage
can be programmed for a JOB.
The saved settings are automatically set when the JOB is retrieved.
Settings that are temporarily changed and not saved are active until the power is turned
OFF
or
another JOB is retrieved.
Batch separation
The machine pauses for the time entered on the
Gap timing
screen, and then resumes a series
of processing.
< STACKER >
End mark
Processing is executed with the interval set in
Batch separation
between a document with end
mark printed on it and the next one.
Stack priority
This sets speed of a fi nished product to be ejected from the exit of the machine to the
exit tray
.
REFERENCE
STACKER
is active after the power is turned
OFF
as well. You cannot program this for a JOB.
To Next Page
Loading...
Need help?
General
