Duplo DC-646 - J8 EXIT TRAY

2
185
Troubleshooting
When a Document Jam Has Occurred
5
J8 EXIT TRAY
A document jam has occurred in the
exit tray
.
Follow the procedure below to remove the jammed document.
Tighten the fi xing screws (two of each) of the
creaser module
and the
cutter module
.
Connect the connectors of the
creaser module
or
the
cutter module
.
(The fi gure on the right shows a view from the
non-operator’s side;
● Left side connector:
Creaser module
● Right side connector:
Cutter module
)
Close the
top cover 2
and the
top cover 3
.
Press the STOP key to clear the error.
The machine is reset and the error message is
cleared.
Remove document
from exit tray
to clear
J8-*