EasyManuals Logo

Duplo DC-646 User Manual

Duplo DC-646
244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
46
Correcting the JOB Settings
This section describes how to correct the JOB settings and to overwrite them.
Make sure that the standby screen is displayed on the LCD
panel.
Press the F key.
Use the CURSOR (Down) key to select
Enter JOB
and press the
SET key.
The JOB numbers are displayed in ascending order.
Use the CURSOR (Up/Down) key to select the JOB number and
press the SET key.
Press the SET key or CURSOR (Down) key to select an item.
Follow the steps in Programming a JOB in Advanced Mode for
each setting.
(P.34 Programming a JOB in Advanced Mode)
Select menu
Retrieve JOB
Enter JOB
Settings1
1:DUPLO
2: JOB***
3: [No Data]
JOB001entry
(
REFERENCE
If you retrieve and correct the stored JOB with the
Apply
shrinkage
or the
Adjust all
function, the details of the function
are displayed after the
Speed
screen of step 27 in Programming
a New JOB (Advanced Mode).
1. If you select
Yes
on the
Clear adjust all & Apply shrinkage?
screen, the correction value of
Adjust all
is reset. If you select
No
, the correction value is not changed.
Apply shrinkage
Before After
Function
***.*mm ***.*mm
Adjust all
Function
+ *.*mm
adjust all &
Apply shrinkage?
Yes No
Clear
2. Correction details of
Apply shrinkage
are displayed.
Con rm the details and press the CURSOR (Down) key.
3. Correction details of
Adjust all
are displayed.
Con rm the details and press the CURSOR (Down) key.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Duplo DC-646 and is the answer not in the manual?

Duplo DC-646 Specifications

General IconGeneral
BrandDuplo
ModelDC-646
CategoryCutter
LanguageEnglish

Related product manuals