Duplo DC-646 - When Service Call Messages Appear

170
Message Status and Solution
Status: Communication error in the DC-646.
Solution: Turn OFF the power and then turn ON again in a few
seconds. If the same error message remains displayed, write
down the message and contact our service person.
Status: Barcode or REG mark reading error.
Solution: 1. Remove the document and press the STOP key.
2. Turn OFF the power and then turn ON again in a few
seconds. If the same error message remains displayed,
write down the message and contact our service person.
Status: Error in the elevator.
Solution: 1. Remove the documents from the feed tray and then press
the STOP key.
2. Turn OFF the power and then turn ON again in a few
seconds. If the same error message remains displayed,
write down the message and contact our service person.
Status: Error in the lower tool area of the creaser module.
Solution: Turn OFF the power and then turn ON again in a few
seconds. If the same error message remains displayed, write
down the message and contact our service person.
When Service Call Messages Appear
E00-*
MAIN-PANEL
E01-*
CCD ERROR
Contact service
person
E01-*
E02-*
ELEVATOR
Contact service
person
E02-*
E03-*
CREASE LOWER
Contact service
person
E03-*
Contact service
person
E00-*