EasyManuals Logo

Duplo DC-646 User Manual

Duplo DC-646
244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
2
13
Preparation Before Use
Before Using This Machine
1
Attaching the Card Stacker
Remove the
side guide
and the
back
guide
, and
set the
exit tray
to upper position.
Attach the
card stacker
when making card-sized products.
Locate the
card stacker
on the
exit tray
with it
in contact with the
stopper
as shown in the right
gure.
Use the
card stacker
when the length of a nished product is 150 mm or shorter.
In the case that the nished products are not aligned on the
exit tray
even the nished
product size is 150 mm or longer, use the
card stacker
with the
stopper
. Adjust the
stopper
according to the nished product length.
REFERENCE
Press and hold the TEST key to perform a test run
for one sheet.
Upper
position
Pressing and holding the TEST key enters the
stacker setup mode
.
REFERENCE
Stopper
(Screw head)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Duplo DC-646 and is the answer not in the manual?

Duplo DC-646 Specifications

General IconGeneral
BrandDuplo
ModelDC-646
CategoryCutter
LanguageEnglish

Related product manuals