220
Index
3 digits (barcode) ....................................128
A
About Slitter Tool Intersection Correction
..206
AC inlet ........................................................3
Adjust All ................................................8,69
Advanced mode ........................................30
Advanced Mode ...................................34,96
Airfl ow .......................................................73
Airfl ow adjustment knob ............................2
Air knife ...............................33,40,57,60,123
Air Knife ...................................................125
Apply shrinkage ............................59,66,129
Attaching the Card Stacker .....................13
Attaching the Upper Guide ......................12
Auto trail cut ................33,41,57,62,108,124
B
Back guide .............................................3,13
Back guide (for feed tray) .............. 11,51,71
Barcode .............................................23,8,59
Barcode digit ........................................58,63
Barcode position area ............................151
Basic mode ..........................................58,64
Batch separation ......................................59
Batch Separation ...............................67,132
C
Cards per document .................................99
Card stacker ................................................4
Center slitter module 1 ...............................5
Center slitter module 2 ...............................5
Change Tool Settings .............................126
Cleaning mode ............................................8
Cleaning the Conveyance Rollers .........204
Cleaning the Sensors .............................197
Cleaning the Skew Correction Belt .......205
Cleaning the Slitter Tool ........................196
Clear ...........................................................96
CLEAR key ..................................................7
Connect .....................................................96
Control panel ..............................................2
Convert to a PDF template with cut block impositions
..151
Counter ........................................................8
CPM off pos adj ............................58,64,128
CPM on pos adj .............................58,64,128
Crease ..............................................18,20,40
Crease depth ................33,41,57,62,107,126
Crease position ....................................32,33
Creaser ......................................................30
Creaser module .....................................5,18
Crop marks ..............................................151
Cross tool module ...............................34,43
Curled Document ......................................75
CURSOR (Down) key ..................................6
CURSOR (Left) key .....................................6
CURSOR (Up) key .......................................6
Cut 18,20,39
Cut position ...............................................32
Cutter .........................................................30
Cutter module ........................................5,18
Cut trim mode ............................30,32,39,61
Cut Trim Setting ...............................107,125
D
Daily Maintenance ..................................196
DBL detection ......................................58,63
DC<>SYS Change .....................................96
DIRECT ........................................ 95,112,151
Double Feed Detection ...........................127
DOWNLOAD ..............................................95
Driver Installation Procedure ..................82
Driver Uninstallation Procedure ..............91
E
Elevator down switch .................................3
Emergency Stop Function ......................xiv
Emergency stop switch .............................2
End mark .......................................59,67,131
Enter JOB ....................................................8
Exit tray ....................................................3,4
F
Fan reg ........................................33,40,57,60
Fan Register ............................................124
Feeder capacity ............................58,64,127
Feed tray ......................................................2
F key ............................................................6
Front cover ..................................................2
Full bleed mode .........................30,31,39,61
To Next Page
Loading...
Need help?
General
