79
Programming a JOB for DC-646 Via Computer (PC Controller)
4
PC Controller Installation Procedure
IMPORTANT
Make sure that the DC-646 is turned
OFF
.
Turn the computer
ON
to start the Windows.
Insert the CD-ROM that came with the DC-646 into your computer’s CD-ROM drive.
● Windows 10, Windows 8.1, and Windows 7 allow multiple users on one computer at
the same time.
Please make sure that only one user is logged in when the PC Controller is installed.
● If you are requested to enter a password of administrator account during installation of
the PC Controller, enter the password of the user with administrative rights shown.
● The following instructions use the screenshots appeared on Windows 10. If you are
using Windows 8.1 or Windows 7, the screenshots vary.
● If you are using Windows 10 or Windows 8.1, a
SmartScreen warning message
may appear while
installation is in progress.
Click
More info
, and then click
Run anyway
to
proceed with the installation.
This software has been thoroughly tested and can be
used without any problems.
● If you upgrade the PC Controller, the data (*.M646, *.Am646, *.Jm646) that has
been saved or modified is deleted from the installation folder (ex.: C:\Duplo Seiko
Corp\DC-646 PC Controller V1.XX) of the previous version. Back up the data before
upgrading the PC Controller if necessary.
After installing the new version of the PC Controller, the installation folder (ex.: C:\
Duplo Seiko Corp\DC-646 PC Controller V1.XX) of the previous version remains. It is
recommended that you delete the folder manually. (The upgraded PC Controller works
correctly even if the folder is not deleted.)
REFERENCE
REFERENCE
The
Auto Play
screen appears.
Click
Open folder to view fi les
.
A message appears in the lower right corner of the
screen. Click the message.
The message does not appear except for Windows 10
and Windows 8.1.
The message does not appear except for Windows 10
and Windows 8.1.
To Next Page
Loading...
Need help?
General
