Duplo DC-646 - How to Use Template

155
2
PDF Template
4
Programming a JOB for DC-646 Via Computer (PC Controller)
Select
Disable
under
REG. Mark
.
● Converting to a PDF template with cut block impositions
If the JOB cannot be converted to a template with cut
block impositions because there is no fi nished product
of the same size, the message as shown on the right
appears.
If you click
YES
, a PDF template with all the cut/
crease lines is saved.
If you click
NO
, the
DIRECT
screen reappears.
How to Use Template
If you install the PC Controller, a shortcut of
DC-646Job
Template
is automatically created on the desk top.
Double-click the shortcut.
A template is a collection of JOB samples that the DC-646 can process.
You can carry out the JOB that you select.
If you select the
Convert to a PDF template with
cut block impositions
check box when saving the
JOB in the
DIRECT mode
, the JOB can be converted
to a PDF template with cut block impositions as
programmed in the
WIZARD mode
, and can be
saved. Finished products of the same size are
converted to a PDF template.