2
169
Troubleshooting
When Messages Appear
5
Message Status and Solution
Status :
Solution : Press the STOP key to clear the error.
Status: Processing positions of pattern 1 and pattern 2 by the rotary
tool module are overlapped. (on
RTM on pos adj
and
RTM off
pos adj
screens in
Settings2
)
Solution: Correct the value(s) so that the processing positions are not
overlapped.
. Status: Value(s) for
Apply Shrinkage
or
Adjust All
are out of
specifi cations. (→P.216 Specifi cations)
Solution: Enter correct value(s).
The gutter slits
are output on
the exit tray on
this job.
to clear
RTM pos. adj.
in Setting 2
are invalid.
Please correct.
1. The message appears when the slit positions that
make the gutter slits less than 5 mm that is out of the
specifi cations are entered and the barcode is read.
2. The message appears when the slitters allocations disable
the gutter defl ector to drop the gutter slits and the JOB is
about to be processed.
Apply shrink. or
Adj. all setting
are invalid.
Please correct.
To Next Page
Loading...
