Correcting the JOB Settings
47
Programming a JOB on the Control Panel
2
When setting for the last item is completed, the display as shown
on the right appears.
If you save the changes as the currently selected JOB number,
press the CURSOR (Up/Down) key to select
Overwrite
JOB001
,
and then press the SET key.
If you save them as a diff erent JOB number, press the CURSOR
(Up/Down) key to select
Save as diff erent JOB no.
and then
press the SET key.
The message
Saving JOB
appears on the screen and the
changed JOB settings are saved.
The standby screen reappears.
The JOB number and the JOB name that have just been saved
are displayed.
Overwrite JOB001
Save as
diff erent JOB no.
Job001entry
001: DUPLO
Sheets
0
- - - - - - - - - -
This JOB is
locked.
Cannot overwrite
REFERENCE
If you overwrite the locked JOB, the message as shown on the
right appears.
To overwrite the locked JOB, unlock the JOB fi rst.
(→P.56 Unlocking a JOB)
4. Correction details of
Adjust all
are displayed.
Confi rm the details and press the CURSOR (Down) key.
Adjust all
Function
+ *.*mm
To Next Page
Loading...
