147
2
Messages
4
Programming a JOB for DC-646 Via Computer (PC Controller)
Display Status and Solution
When a JOB (no lead margin or no trail margin, two or more
cuts) is processed with the
Cut Trim Setting
set to
Full
bleed mode
, the fi rst row of cards or the last row of cards
on the document will be cut into pieces. Then the
Cut Trim
Setting
will be set to
No bleed mode
.
The gutter slits are less than 5 mm.
The gutter slits are output on the
exit tray
on this JOB.
The gutter slits are output on the
exit tray
on this JOB.
The gutter slits are output on the
exit tray
on this JOB.
Pressing OK continues the processing.
The screen appears when a stored JOB in the DC-646 is
retrieved and then the START key is clicked.
To Next Page
Loading...
