Duplo DC-646 - Page 182

162
When Messages Appear
When Messages Appear
Message Status and Solution
Status: There is a document jam in the margin slitter module or slot 2.
Solution: Remove the document from the margin slitter module or slot
2 and then press the STOP key.
(→P.177 J5 MSM/SLOT2)
Status: There is a document jam in slot 3 or slot 4.
Solution: Remove the document from slot 3 or slot 4 and then press
the STOP key.
(→P.180 J6 SLOT3/4)
Status: There is a document jam in the cut or crease area.
Solution: Remove the document from the cut or crease area and then
press the STOP key.
(→P.182 J7 CUT, CREASE)
Status: There is a document jam in the document exit area.
The exit tray has become full during processing.
Solution: Remove the document from the exit area and then press the
STOP key. Or remove the documents on the exit ray.
(→P.185 J8 EXIT TRAY)
J6-*
J5-*
MSM/SLOT2
J5-*
Remove document
from cut/crease
area to clear
Remove document
from SLOT3/4
to clear
Remove document
from MSM/SLOT2
to clear
J6-*
SLOT3/4
J7-*
CUT.CREASE
J7-*
J8-*
EXIT TRAY
J8-*
Remove document
from exit tray
to clear