200
Daily Maintenance
Daily Maintenance
Loosen the two fi xing screws of the module in slot 4.
Grasp the handles to take out the module from slot
4 by lifting it up.
Clean the sensor on the right side of slot 4 with an
air blower.
Slowly lower the module in slot 4. Check to see
that the pins on both sides are securely fi tted in the
module.
Enlarged view
Tighten the two fi xing screws of the module in slot 4.
Slot 4
Operator’s side
Air blower
Slot 4
Slot 4
Slot 4
Operator’s side
Operator’s side
Operator’s side
Slot 4
Operator’s side
To Next Page
Loading...
