2
7
Part Names and Their Functions
Before Using This Machine
1
No. Name Function
10 NUMERIC key Press this to program a JOB and to enter preset count.
11 CLEAR key Press this to clear the entered value when programming a JOB.
Press this to clear the count of sheets processed in the count-up
mode. Press this to clear the count of sheets processed in the
preset count mode, which switches to the count-up mode.
12 SET key Press this to set selection/entry.
13 JOG key Press this to eject the document from the machine when a
document jam has occurred.
14 TEST key Press this to process one sheet of documents
for a test run.
Press this to check if a fi nished product is made as it is
programmed.
When the card stacker is attached, pressing and holding the
TEST key stops fi nished products at the ejected area for about
one minute for guide adjustment.
15 START key Press this to start processing documents. The START key light
turns green when the machine is ready to process the document
in this machine. This key is inactive when the light is red. In this
case, the machine may be running or having an error.
When you press and hold the START key when the machine is
ready for operation, the machine enters the pause feeding mode.
When you press the START key in the pause feeding mode, the
machine starts operation. When you press and hold the START
key during operation, the machine enters the pause feeding
mode.
16 STOP key Press this to switch the current screen to the main screen or to
stop processing.
11 12
15
16
141310
To Next Page
Loading...
Need help?
General
