20
Before Preparing a Document
Slit
: Up to
six slits can be made on one document.
Up to
eight slits can be made with the optional modules.
Slit 1 and Slit 2 are for cutting the margins at both side edges.
Cut
: Up to 30 cuts
can be made on one document.
Crease
: Up to 20 creases
can be made on one document.
Slit/Cut/Crease Limitations
There are limitations for slit/cut/crease process on the DC-646.
Slit 2 Slit 4 Slit 6 Slit 5 Slit 3 Slit 1
Cut 1
Crease 1
Cut 2
Cut 3
Crease 2
Cut 4
Lead margin:
3.0 mm–
Card length:
50 mm–
Center margin:
3 mm–
(More margin
may be required
depending
on document
types.)
Trail margin:
5 mm–
Right margin:
3.2–55 mm
from the right edge
Gutter:
5–15 mm
Card width:
48 mm
3.2–55 mm
from the left edge
Left margin:
Document feed direction
To Next Page
Loading...
Need help?
General
