Duplo DC-646 - Page 81

61
2
Function Setting
Basic Operations
3
●
Every**sht
: You can set 2 to 9999.
For example, if you set two sheets, REG mark is read once in two sheets
(1st, 3rd, 5th, ...). Rejected sheets are included in the number.
●
**.*mm or more
: You can set 0.2 to 12.0. If you set **mm and the diff erence between
the REG mark and the current slit position is under ** mm, the
slit position does not move.
**.*mm or more
is used when the
diff erence is large and REG mark needs to be compensated.
REFERENCE
Read REG (REG mark reading accuracy)
Selected accuracy is enabled when REG mark is read.
Normal
: Reads REG mark with normal accuracy.
Fine
: Improves REG mark reading accuracy and compensates
printing position misalignment fi ner. Changing the setting
from
Normal
to
Fine
for higher reading accuracy decreases
processing speed as compared with
Normal
.
REG mark spec
When using specially treated documents (→ P.23 IMPORTANT),
print a bold REG mark on them in advance. Then, select
BOLD
and
press the SET key or the CURSOR (Down) key.
REG mark spec
Settings1
Standard Bold
*/**
Settings1
Read REG
Normal Fine
Slitter guide
When no slitters are in use for performing a JOB, these slitters
act as document guides to stabilize the document conveyance.
Recommended for light weight documents.
Use the CURSOR (Right/Left) key to select
ON
or
OFF
and press
the CURSOR (Down) key.
Even when setting is
OFF
, the
margin slitter
acts as a guide.
Slitter guide
ON OFF
Settings1
*/**
• If the document has no lead margin or trail margin, select
No bleed mode
.
• The above screen appears only when a value is entered to
Cut
. (→P.40 Cut)
REFERENCE
Cut trim mode
The lead margin, the trail margin and gutters are chopped up and
dropped into the
waste box
.
Use the CURSOR (Right/Left) key to select
Full bleed mode
,
No
bleed mode
, or
Process all
and press the CURSOR (Down) key.
Full bleed mode
: Chops up the lead margin and the trail margin, and gutters of 48.9 mm
or shorter, then drops into the
waste box
.
No bleed mode
: Chops up gutters of 48.9 mm or shorter.
Process all
: Ejects all of the cut pieces to the exit tray, except that the lead margin and
gutters of 27.9 mm or shorter and the trail margin of 49.8 mm or shorter are
chopped up.
Cut trim mode
Settings1
Full bleed mode
*/**