Special instructions
ICC424HF-CN1EN2.pdf 2012-11-23
High pressure cleaning
Do not spray directly onto electrical components.
Do not use high pressure cleaning for
dashboard/display.
Do not use high pressure cleaning for
dashboard/display.
The Electrical Drive Control and the computer
box may not be washed with high pressure
cleaning and not at all with water. Clean them
with a dry wiper.
The Electrical Drive Control and the computer
box may not be washed with high pressure
cleaning and not at all with water. Clean them
with a dry wiper.
Detergent that can destroy electrical parts, or
which is conductive, must not be used.
Detergent that can destroy electrical parts, or
which is conductive, must not be used.
Place a plastic bag over the fuel filler cap and secure
with a rubber band. This is to avoid high pressure
water entering the vent hole in the filler cap. This could
cause malfunctions, such as the blocking of filters.
Never aim the water jet directly at the fuel tank
cap. This is particularly important when using a
high-pressure cleaner.
Never aim the water jet directly at the fuel tank
cap. This is particularly important when using a
high-pressure cleaner.
Fire fighting
If the machine catches fire, use an ABC-class powder
fire extinguisher.
A BE-class carbon dioxide fire extinguisher can also
be used.
Roll Over Protective Structure (ROPS), ROPS
approved cab
If the machine is fitted with a Roll Over
Protective Structure (ROPS, or ROPS approved
cab) never carry out any welding or drilling in
the structure or cab.
If the machine is fitted with a Roll Over
Protective Structure (ROPS, or ROPS approved
cab) never carry out any welding or drilling in
the structure or cab.
Never attempt to repair a damaged ROPS
structure or cab. These must be replaced with
new ROPS structure or cabs.
Never attempt to repair a damaged ROPS
structure or cab. These must be replaced with
new ROPS structure or cabs.
Battery handling
When removing batteries, always disconnect the
negative cable first.
When removing batteries, always disconnect the
negative cable first.
10
To Next Page
Loading...
