Dynapac CC424HF - Alarm Descriptions; Driving; Operating the Roller

Operation
ICC424HF-CN1EN2.pdf 2012-11-23
Alarm descriptions
Symbol Designation FunctionSymbol Designation Function
Warning lamp, hydraulic filter If the lamp comes on while the engine is running at full
speed, the hydraulic filter must be changed.
Warning lamp, hydraulic filter If the lamp comes on while the engine is running at full
speed, the hydraulic filter must be changed.
Warning lamp, air filter If the lamp comes on while the engine is running at full
speed, the air filter must be cleaned or replaced.
Warning lamp, air filter If the lamp comes on while the engine is running at full
speed, the air filter must be cleaned or replaced.
Warning lamp, battery charging If the lamp comes on while the engine is running, the
alternator is not charging.
Stop the engine and locate the fault.
Warning lamp, battery charging If the lamp comes on while the engine is running, the
alternator is not charging.
Stop the engine and locate the fault.
Warning light, engine temperature If the lamp comes on, the engine is too hot. Stop the
engine immediately and locate the fault.
Refer also to the engine manual.
Warning light, engine temperature If the lamp comes on, the engine is too hot. Stop the
engine immediately and locate the fault.
Refer also to the engine manual.
Warning lamp, hydraulic fluid
temperature
If the lamp comes on, the hydraulic fluid is too hot.
Do not drive the roller. Cool the fluid by allowing the engine
to idle and locate the fault.
Warning lamp, hydraulic fluid
temperature
If the lamp comes on, the hydraulic fluid is too hot.
Do not drive the roller. Cool the fluid by allowing the engine
to idle and locate the fault.
Driving
Operating the roller
Under no circumstances is the machine to be
operated from the ground. The operator must be
seated inside the machine during all operation.
Under no circumstances is the machine to be
operated from the ground. The operator must be
seated inside the machine during all operation.
Fig. Control panel
1. Rpm switch
2. Manual sprinkler
3. Automatic sprinkler
1
2
3
Activate working revs = HI (1).
Check that the steering is working correctly by turning
the steering wheel once to the right and once to the
left while the roller is stationary.
When compacting asphalt, don't forget to turn on the
sprinkling system (2) alt. (3).
Make sure that the area in front of and behind the
roller is clear.
Make sure that the area in front of and behind the
roller is clear.
50