Geometry
CrossSection
Mouth
Radius
> Enter radius (r).
Reduction area > Enter 0 (recommended) or value for cross section area reduction (for example due to
installations in the pipe or channel).
Sludge Level
> Enter thickness of sludge / sediment layer (see Figure 12 on page 47).
Click Apply to save settings for mouth cross-section.
CrossSection
Irregular Polynom
x-Axis
> Enter values for width (x)
y-Axis
> Enter values for cross section height (y)
> Click + to add row for additional values or – to delete values.
Click Apply to save settings for irregular cross-section.
Programming
Page 46 March 2021HYB-UM-03155-EN-03
To Next Page
Loading...
