dynasonics Badger Meter IS-6000 Doppler - Page 45

 Geometry
CrossSection
 J Trapezoid
Width B
> Enter upper width (B).
Width b
> Enter lower width (b).
Height H
> Enter upper height H.
Height h
> Enter lower height h.
Reduction area > Enter 0 (recommended) or value for cross section area reduction (for example due to
installations in the pipe or channel).
Sludge Level
> Enter thickness of sludge / sediment layer (see Fi. 22).
 Click Apply to save settings for J trapezoid cross-section.
CrossSection
 Egg
Radius
> Enter radius.
Reduction area > Enter 0 (recommended) or value for cross section area reduction (for example due to
installations in the pipe or channel).
Sludge Level
> Enter thickness of sludge / sediment layer (see Figure 12 on page 47).
 Click Apply to save settings for egg cross-section.
Programming
Page 45 March 2021 HYB-UM-03155-EN-03