dynasonics Badger Meter IS-6000 Doppler - Page 44

 Geometry
CrossSection
 U-Profile
Height
> Enter height (H) of cross-section as shown in drawing above.
Radius
> Enter radius of semi circle.
Reduction area > Enter 0 (recommended) or value for cross section area reduction (for example due to
installations in the pipe or channel).
Sludge Level
> Enter thickness of sludge / sediment layer (see Figure 12 on page 47).
 Click Apply to save settings for trapezoid cross-section.
CrossSection
 Trapezoid
Width
> Enter width (B).
Height
> Enter height (H).
Angle_left
> Enter left angle (α).
Angle_right
> Enter right angle (β).
Reduction area > Enter 0 (recommended) or value for cross section area reduction (for example due to
installations in the pipe or channel).
Sludge Level
> Enter thickness of sludge / sediment layer (see Figure 12 on page 47).
 Click Apply to save settings for trapezoid cross-section.
Programming
Page 44 March 2021HYB-UM-03155-EN-03