5. Press the ▼ button: if DHCP OFF appears, press the ► button to change the message to DHCP ON.
6. Press ESC button twice, when asked to exit the menu press OK button.
7. At the next request to save the configuration, press OK.
If the control unit is in hardware maintenance status (DIP 1 SW2 on), it is also possible to access the
control unit via LAN cable by entering the address https://192.168.1.100.
By leaving or setting DHCP ON, you will be able to configure the connection parameters manually. To
insert a division point, press button 1 twice; to delete the last displayed character, press the ▼ button. If
the address or value inserted is not valid, the control panel will not accept it and the previous address or
value will be kept. For manual configuration:
1. When the display shows DHCP OFF press the ▼ button. IP and the current IP address will appear.
To change it, type the new IP address using the keypad.
2. Press ▼. SUBNET MASK and its value will appear. To change it, type the new Subnet Mask value
using the keypad.
3. Press ▼. GATEWAY and the Gateway IP address will appear. To change it, use the keypad to type
in the new Gateway IP address.
4. Press ▼. DNS PRIM. and the IP address of the primary DNS server appear. To change it, type the
new IP address of the primary DNS server using the keypad.
5. Press ▼. DNS SECOND. and the IP address of the secondary DNS server appear.
1.1.4 Connecting to the control panel via WLAN (WiFi)
The computer can be connected to the control panel via WLAN, if the optional IT700-WiFi card is present.
Configure WiFi connectivity parameters via web server or keypad.
To use the keypad:
1. Enter the installer code (default 00000) on the keypad and press the MENU button on the keypad.
2. Use the ▼ button to scroll through the menu until CONNECTIVYTI appears and press the OK button.
3. Use the ▼ button to scroll through the menu until WIFI appears and press the OK button.
4. If WIFI appears: OFF press the ► button which changes the message to WIFI: ON.
5. Press ▼. WIFI appears: SSID. Press the OK button and use the keypad to enter the SSID code that
identifies the WiFi network. Press OK to confirm.
6. Press ▼. WIFI appears: PASSWORD. Press the OK button and use the keypad to enter the password
that allows access to the WiFi network. Press OK to confirm.
7. Press the ▼ button: if DHCP OFF appears, press the ► button to change the message to DHCP ON.
8. Press ESC button twice and then press OK button to exit the menu.
9. Press OK to save the changes.
By leaving or setting DHCP OFF, you will be able to configure the connection parameters manually. To
insert a division point, press button 1 twice; to delete the last displayed character, press the ▼ button. If
the address or value inserted is not valid, the control panel will not accept it and the previous address or
value will be kept.
For manual configuration:
1. When the display shows DHCP OFF press the ▼ button. IP and the current IP address will appear.
To change it, type the new IP address using the keypad.
2. Press ▼. SUBNET MASK and its value will appear. To change it, type the new Subnet Mask value
using the keypad.
3. Press ▼. GATEWAY and the Gateway IP address will appear. To change it, use the keypad to type
in the new Gateway IP address.
4. Press ▼. DNS PRIM. and the IP address of the primary DNS server appear. To change it, type the
new IP address of the primary DNS server using the keypad.
5. Press ▼. DNS SECOND. and the IP address of the secondary DNS server appear. To change it, type
the new IP address of the secondary DNS server using the keypad.
To Next Page
Loading...
