Elkron MEDEA - Default Access Codes

MEDEA Programming Manual
15
2.1.1 Default access codes
The MEDEA control panels are provided with default codes when they leave the factory. These codes are
restored if the control panel is reset.
The Installer and Technical Manager codes are enabled at the factory and automatically deactivated when
a valid Master or User code is entered for the first time.
Code type
Level
Default code
Assigned
sectors
Enabled
when
leaving the
factory
Enable time
(once enabled)
User
2
See Table 5
Sector 1
No
Until expressly disabled
Master
2
111111
All
Yes
Permanent
Technical
Manager
3
222222
All
Yes
As programmed:
• always
• never
• timed (2 hours)
• until the first valid user code is
entered
Installer
3
000000
All
Yes
As programmed:
• always
• never
• timed (2 hours)
• until the first valid user code is
entered
Table 4 - Access codes
CPU
User n.
Default code
MEDEA 32
2…51
000020, 000030, 000040 … 000490, 000510
MEDEA 64
2…151
000020, 000030, 000040 … 001490, 001510
MEDEA 160
2…201
000020, 000030, 000040 … 001990, 002010
Table 5 - Default user access codes