5.25 Zigbee Home Automation Modules
This can be used to view the ZigBee home automation modules in the system, divided into three tables:
Relay Modules, Shutter Modules and Temperature Control Devices.
It is accessed through the PROGRAMMATION → Zigbee Peripheral → Zigbee Domotic Modules menu.
Figure 96 - Zigbee home automation modules (relays and shutters)
The tables show:
• NUMBER: This is the sequential number of acquisition of the module.
• PHYS.ADDRESS: This is the physical address of the module.
• DESCRIPTION: This is the alphanumeric label used to identify the module more easily.
The following are also provided for the shutter modules:
• APERTURE TIME: This is the pre-set time for opening the shutter.
• CLOSURE TIME: This is the pre-set time for closing the shutter.
Double-click on the flasher line to open a pop-up window where it is possible to enter the identification
label of the module in Description. Use only alphabetic characters, including accented characters,
numbers, and spaces.
The following buttons appear under the tables:
• Modify: This can be used to configure the module highlighted in the table.
• CSV: This can be used to export the modules table to a “.csv” file, which can be opened with a
spreadsheet.
• PDF: This can be used to export the modules table to a PDF file.
The < and > buttons at the bottom right are used to navigate between the pages of the modules, if their
number is greater than the number that can be displayed in a single screen.
To Next Page
Loading...
