4.3.3 Radio Supervision
This can be used to configure the test regarding the connections with the various wireless devices in the
system.
It is accessed through the CONFIGURATION → Central Unit → Automated Test menu.
Figure 18 - Wireless supervision
The wireless supervision menu and can be used to set:
• Interval (hours): This is the time interval, in hours, after which the control panel sends the supervision
event to the single device with which it was not able to establish communication during this time.
4.4 Connectivity
This function can be used to configure the data related to the connectivity of the control panel.
To go directly to the type of connectivity you are interested in, without manually scrolling through the
submenu page, click on the LAN Port Parameters, Wi Fi Parameters, Cloud links located below the title.
4.4.1 LAN Port Parameter
This can be used to configure the operating parameters of the LAN connection of the control panel.
It is accessed through the CONFIGURATION → Central Unit → Connectivity menu.
Figure 19 - Ethernet parameters
The menu shows the following items and can be used to set:
• Enable: This can be used to enable and disable the connection to the LAN.
• DHCP (Automatic IP): This can be used to enable and disable the DHCP client (Dynamic Host
Configuration Protocol), which allows the control panel to automatically receive the IP configuration
needed to establish the connection when it connects to a network where there is a DHCP server.
To Next Page
Loading...
Need help?
General