Elkron MEDEA - Status Leds; Relay Modules; Shutter Modules

46
MEDEA Programming Manual
4.7.4 Status Leds
This can be used to enable and disable the ZigBee flashers.
It is accessed through the CONFIGURATION → Zigbee Peripherals menu.
Figure 37 - ZigBee flashers
The available parameters and functions are the same as those of the photo sensors (paragraph 4.7.1), to
which you can refer for descriptions.
4.7.5 Relay modules
This can be used to enable and disable the ZigBee relay modules.
It is accessed through the CONFIGURATION → Zigbee Peripherals menu.
Figure 38 - ZigBee relay modules
The available parameters and functions are the same as those of the photo sensors (paragraph 4.7.1), to
which you can refer for descriptions.
4.7.6 Shutter modules
This can be used to enable and disable the ZigBee shutter modules.
It is accessed through the CONFIGURATION → Zigbee Peripherals menu.
Figure 39 - ZigBee shutter modules
The available parameters and functions are the same as those of the photo sensors (paragraph 4.7.1), to
which you can refer for descriptions.