Elkron MEDEA - Page 31

MEDEA Programming Manual
29
EXAMPLES OF CALL CYCLES
In the following examples, five numbers are programmed on the control panel for sending voice
messages:
• Number : Intrusion alarm + sectors status.
• Number : Hold-up alarm.
• Number : Intrusion alarm.
• Number : Intrusion alarm.
• Number : Intrusion alarm.
• Number : Intrusion alarm.
• Number : Power failure alarm + sector status.
For the sake of simplicity, in this example, we will assume that no called number picks up (when a
called number picks up, it is deleted from the call cycle for that event).
Event
Mode 1 cycle
Mode 2 cycle
System arming
     
     
intrusion alarm
           
  
           
  
Disarming with hold-up code
  
  
Power failure alarm and
intrusion alarm shortly after
  [intrusion]      
         
  [intrusion]      
         
Mains failure alarm and shortly
after disarming using an access
code
  [disarming]    
  [disarming]    
Table 9 - Call cycle examples