Double-click on the group line to open a pop-up window.
Figure 52 - Output group customisation
In the pop-up window you can:
• Enter the identification label of the output group in Description.
Click on the Save button to save the changes, the Close button to close the window and not save the
changes.
The following buttons (some are enabled only by highlighting a sector of the table) are shown below:
• Modify: This can be used to modify the configuration of the output highlighted in the table.
• CSV: This can be used to export the outputs table to a “.csv” file, which can be opened with a
spreadsheet.
• PDF: This can be used to export the outputs table to a PDF file.
The < and > buttons at the bottom right are used to navigate between the pages of the output groups, if
their number is greater than the number that can be displayed in a single screen.
To Next Page
Loading...
