• Enable or disable the Gong function.
• Enable or disable the Masking function.
• Enable or disable the Buzzer function.
• Enable or disable the fire button for the fire alarm (Fire Key).
• Enable or disable the emergency button for the emergency alarm (rescue Key).
• Enable or disable the silent panic button for the silent panic alarm (Silent Panic Key).
• Combine the 1...0 buttons on the keypad with scenarios. Scenarios are programmed in the Scenarios
submenu.
IMPORTANT! Enabling of the fire, silent panic or emergency buttons has priority over any scenario
associated with the button.
Click on the Save button to save the changes, the Close button to close the window and not save the
changes.
The following buttons appear under the table:
• Modify: This can be used to modify the configuration of the keypad highlighted in the table.
• CSV: This can be used to export the keypad table to a “.csv” file, which can be opened with a
spreadsheet.
• PDF: This can be used to export the keypads table to a PDF file.
• Locate: This activates the procedure for locating the device.
• End Locate: This ends the localisation procedure.
The < and > buttons at the bottom right are used to navigate between the pages of the keypads, if their
number is greater than the number that can be displayed in a single screen.
To Next Page
Loading...
