Emulex Fibre Channel User Manual

Boot for the Fibre Channel Protocol User Manual P010096-02A Rev. A
List of Tables
10
List of Tables
Table 2-1 Boot from SAN Procedures...............................................................15
Table 3-1 Utilities that Install and Update Boot Code...........................................27
Table 3-2 Utilities that Enable Boot Code.........................................................27
Table 4-1 Valid ALPA Values.........................................................................35
Table 4-2 Adapter Defaults ..........................................................................43
Table 5-1 OpenBoot Signature Table...............................................................50
Table 6-1 Adapter Defaults ..........................................................................70
Table 7-1 Adapter Defaults ........................................................................ 101
Table 8-1 x86 BootBIOS Troubleshooting ........................................................ 105
Table 8-2 OpenBoot Troubleshooting ............................................................ 106

Emulex Fibre Channel Specifications

General

Interface Type	Fibre Channel
RAID Support	No
Boot Support	Yes
Data Transfer Rate	32Gbps
Interface	PCIe
Operating Systems Supported	Windows, Linux, VMware
Ports	Single, Dual, or Quad