Emulex Fibre Channel - Scan for Fibre Devices; Figure 7-4 New Boot from SAN Setting

Boot for the Fibre Channel Protocol User Manual P010096-02A Rev. A
7. Configure EFIBoot via UEFI HII (Human Interface Infrastructure) in a UEFI 2.1 System
Scan for Fibre Devices
86
3. Make your selection and press <Enter>. The utility displays the new boot from
SAN setting.
Figure 7-4 New Boot From SAN Setting
Scan for Fibre Devices
To scan for fibre devices:
1. From the Adapter Selection screen, select the adapter that you want to scan for
Fibre devices and press <Enter>.
2. From the Main menu, select Scan for Fibre Devices and press <Enter>. A list of the
discovered targets is displayed. This is only a list of discovered target devices to