Emulex Fibre Channel - Figure 7-20 Delay Device Discovery Screen

Boot for the Fibre Channel Protocol User Manual P010096-02A Rev. A
7. Configure EFIBoot via UEFI HII (Human Interface Infrastructure) in a UEFI 2.1 System
Configure Boot Parameters
100
If both of the conditions exist, typically set this parameter to 20 seconds. However, the
delay only needs to be long enough for the array to be reliably discovered after a reset.
Your value may be different.
To change the delay device discovery value:
1. From the Adapter Selection screen, select the adapter whose device discovery delay
settings you want to change and press <Enter>.
2. From the Configure Boot Parameters menu, Delay Device Discovery and press
<Enter>. The screen becomes editable.
Figure 7-20 Delay Device Discovery Screen
3. Use the +/- keys to change the delay device discovery value in increments of 10
seconds and press <Enter>. The screen is refreshed with the new value.
4. Press <Esc> to return to the EFI utility menu.
5. Select Commit Changes and press <Enter>.