Emulex Fibre Channel - Figure 7-21 Adapter Defaults Menu; Figure 7-22 Adapter Selection Screen

Boot for the Fibre Channel Protocol User Manual P010096-02A Rev. A
7. Configure EFIBoot via UEFI HII (Human Interface Infrastructure) in a UEFI 2.1 System
Reset Emulex Adapters to Default Values
102
2. From the Main menu, select Set Emulex Adapters to Default Settings and press
<Enter>. A menu screen appears enabling you to set defaults or cancel default
settings.
Figure 7-21 Adapter Defaults Menu
3. Select Set Adapter Defaults and press <Enter>. The Adapter Selection screen
appears.
Figure 7-22 Adapter Selection Screen