Emulex Fibre Channel - Page 26

Boot for the Fibre Channel Protocol User Manual P010096-02A Rev. A
2. Boot from SAN
Solaris
26
/dev/dsk/c0t0d0s1 (swap)
/dev/dsk/c0t0d0s0 and /dev/rdsk/c0t0d0s0 (root)
/dev/dsk/c0t0d0s6 and /dev/rdsk/c0t0d0s6 (usr)
/dev/dsk/c0t0d0s7 and /dev/rdsk/c0t0d0s7 (export)
Edit the file to show:
/dev/dsk/c1t1d1s1 (swap)
/dev/dsk/clt1d0s0 and /dev/rdsk/c1t1d0s1 (root)
/dev/dsk/clt1d0s6 and /dev/rdsk/c1t1d0s6 (usr)
/dev/dsk/clt1d0s7 and /dev/rdsk/c1t1d0s7 (export)
17. Reboot the system:
sync
sync
halt
reset-all
18. Boot to disk:
boot disk
The system should boot to the FC disk.
19. View the current dump device setting:
dumpadm
20. Change the dump device to the swap area of the FC drive:
dumpadm -d /dev/dsk/c1t1d0s1
where /dev/dsk/c1t1d0s1 is a sample path to the swap area of the FC drive.