Emulex Fibre Channel - Page 44

Boot for the Fibre Channel Protocol User Manual P010096-02A Rev. A
4. Emulex BIOS Utility
Configure Adapter Parameters
44
EDD 3.0 EDD 3.0 Disabled (EDD 2.1)
Enabled (EDD 3.0)
PLOGI Retry Timer Disabled Disabled
50 msec
100 msec
200 msec
Spinup Delay Disabled Enabled
Disabled
Auto Scan Disabled Enabled
Disabled
Start Unit Disabled Enabled
Disabled
Environmental Variable Disabled Enabled
Disabled
Auto Boot Sector Disabled Enabled
Disabled
Topology Auto (start FC-AL) Auto (start FC-AL)
Point-to-Point
Auto (start Point-to-Point)
FC-AL
Link Speed Auto (highest
successfully
negotiated speed)
Table 4-2 Adapter Defaults (Continued)
Parameter Default Valid Values