Boot for the Fibre Channel Protocol User Manual P010096-02A Rev. A
Table of Contents
5
Configure Boot Parameters........................................................................ 61
Change the Device Path ........................................................................61
Change the Maximum LUNs per Target Setting .............................................62
Set Up Boot Target Scan........................................................................63
Configure Boot Devices .........................................................................65
Cancel a Boot Device............................................................................68
Change Device Discovery Delay................................................................69
Reset to Default Values ............................................................................ 70
Save and Restore Configurations................................................................. 71
Save the Configuration to a File...............................................................72
Batch Configuration .............................................................................73
Update an Adapter’s Firmware or Boot Code ................................................. 76
Update a Single Adapter........................................................................76
Update Firmware or Boot Code Across Multiple Adapters.................................78
EFIBoot Reference .................................................................................. 80
Driver Handle Table Column Definitions .....................................................80
Driver Handle Table Column Definitions .........................................................81
Topology Information...........................................................................81
Arbitrated Loop Operation .........................................................................81
Point-to-Point Operation ...........................................................................81
7. Configure EFIBoot via UEFI HII (Human Interface Infrastructure) in a
UEFI 2.1 System..................................................................................83
Start the Emulex Configuration Utility.......................................................... 83
EFI Utility Conventions in UEFI/HII............................................................84
Configure EFIBoot in UEFI/HII..................................................................... 85
Set Boot from SAN................................................................................... 85
Scan for Fibre Devices ............................................................................. 86
Add Boot Devices.................................................................................... 87
Delete Boot Devices ................................................................................ 89
Change Boot Device Order ........................................................................ 91
Configure Adapter Parameters ................................................................... 93
Change the Topology............................................................................94
Change the PLOGI Retry Timer ................................................................95
Change the Link Speed..........................................................................96
Configure Boot Parameters........................................................................ 97
Change the Maximum LUNs per Target.......................................................97
Change Boot Target Scan Method .............................................................98
To Next Page
Loading...