Endress+Hauser HART Proline t-mass I 300 - Page 96

Commissioning Proline t-mass I 300 HART
96 Endress+Hauser
Configuring the switch output
Navigation
"Setup" menu → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
→  96
Terminal number
→  96
Signal mode
→  96
Switch output function
→  97
Assign diagnostic behavior
→  97
Assign limit
→  97
Assign status
→  97
Switch-on value
→  97
Switch-off value
→  97
Switch-on delay
→  97
Switch-off delay
→  98
Failure mode
→  98
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Operating mode – Define the output as a pulse,
frequency or switch output.
• Pulse
• Frequency
• Switch
–
Terminal number – Shows the terminal numbers
used by the PFS output
module.
• Not used
• 24-25 (I/O 2)
• 22-23 (I/O 3)
–
Signal mode – Select the signal mode for the
PFS output.
• Passive
• Active
*
• Passive NAMUR
–