Endress+Hauser Proline Prosonic Flow 93 - Mechanical Construction

PROline Prosonic Flow 93 FOUNDATION Fieldbus 3 Transducer Blocks (transmission blocks)
Endress+Hauser 149
Totalizer 1 -
System Value
AUTO - OOS Use this parameter to view the total for the totalizer's measured
variable aggregated since measuring commenced. This value can
be positive or negative, depending on the setting selected in the
"Totalizer 1 - Mode" parameter (see Page 150) and the direction of
flow.
 Note!
• The effect of the setting in the "Totalizer 1 - Mode" parameter (see
Page 150) is as follows:
– If the setting is “BALANCE”, the totalizer balances flow in the
positive and negative directions.
– If the setting is “FORWARD”, the totalizer registers only flow in
the positive direction.
– If the setting is “REVERSE”, the totalizer registers only flow in
the negative direction.
• The totalizers' response to faults is defined in the "Totalizer
Handling - Failsafe All" parameter, (see Page 155).
Totalizer 1 -
System Unit
AUTO - OOS Use this parameter to define the unit for the measured variable
selected for the totalizer.
Options:
Metric:
Cubic centimetre
→ cm³
Cubic decimetre
→ dm³
Cubic metre
→ m³
Millilitre
→ ml
Litre
→ l
Hectolitre
→ hl
Megalitre
→ Ml MEGA
US:
Cubic centimetre
→ cc
Acre foot
→ af
Cubic foot
→ ft³
Fluid ounce
→ oz f
Gallon
→ US gal
Million gallon
→ US Mgal
Barrel (normal fluids: 31.5 gal/bbl)
→ US bbl NORM.FL.
Barrel (beer: 31.0 gal/bbl)
→ US bbl BEER
Barrel (petrochemicals: 42.0 gal/bbl)
→ US bbl PETROCH.
Barrel (filling tanks: 55.0 gal/bbl)
→ US bbl TANK
Imperial:
Gallon
→ imp. gal
Mega gallon
→ imp. Mgal
Barrel (beer: 36.0 gal/bbl)
→ imp. bbl BEER
Barrel (petrochemicals: 34.97 gal/bbl)
→ imp. bbl PETROCH.
Factory setting:
Depends on country (dm³...m³ or US gal...US Mgal), corresponds
to the totalizer unit factory setting, (see Page 76 ff.).
 Note!
The unit selected here has no effect on the desired volume unit
which should be transmitted via the FF interface. This setting is
made separately via the appropriate AI Block in the XD_SCALE
parameter group, (see Page 180).
“TRANSDUCER_TOT” (E+H parameters) / base index 1550
Parameter Write access
with operating
mode
(MODE_BLK)
Description